How to Setup The Condor using Zoom

The Condor (MT600) is an easy to install microphone array that is designed to eliminate the need to wire or place a speakerphone on the conference table, and keeps conference rooms clutter free. Created with the vision of a clutter free conference table, the Condor sits above or below your monitor and with a pick up range of up to 30 ft almost any conference room can use the Condor. The Condor has been tested for Zoom Room and Zoom desktop clients. While the Condor can utilize a large variety of speakers for the best user experience we recommend to pair the Condor with a Sound Bar.

  • Huddle Rooms
  • Medium to large conference rooms
  • Classroom and training rooms
How To Install The Condor Mic Array
How To Set Up The Condor With Zoom

Required Hardware

  • MAC or PC For Zoom (See Zoom’s recommended hardware for more information: https://zoom.us/zoomrooms/hardware)
  • PC (Used for a one-time Advanced Condor Test/Setup)
  • Soundbar with Optical In or RCA Audio In
  • Optical or RCA Cable
  • Condor MT600

Step 1. Connect Soundbar

  • Connect Soundbar to the Condor’s Optical OUT or RCA Speaker OUT
  • Tested Soundbar:SB2920-C6

Step 2. Connect Condor

  • Connect the Condor Using USB to either a PC or MAC with Installed Zoom Software
  • The Condor will Power On when connecting via USB (Remain quiet during this process as the Condor will produce a chirping sound that will test for any audio delays).
  • Note: If the steps are followed properly there might not be a need for additional Condor Setup/Settings.
  • If you do experience problems with the delay, click here for additional settings.

Step 3. Zoom Settings

Click here for Instructions