Crestron Integration

 

CRESTRON CERTIFIED MODULE

 

Crestron Details:

This module will control the Speaker & Microphone, Volume & Muting, and Dialing features of the Phoenix Octopus Mixer via RS-232.

This module provides control volume and mute control. The module will poll the device for an update at program start. If needed the Poll_Device command can be triggered to update feedback. This module is System Builder ready.

 

Crestron Hardware Required:	C2I-COM6, C2NCOM-2/3, CNX-COM6, CNX-COM2, SY-COM
Setup of Crestron Hardware:	RS232 Baud: 9600 Parity: None Data Bits: 8 Stop Bits: 1
Cable Diagram:	CNSP-123

---

Control:

Speaker_Volume_Up	D	Push to raise speaker volume
Speaker_Volume_Down	D	Push to lower speaker volume
Speaker_Mute	D	Pulse to toggle speaker mute
Microphone_Volume_Up	D	Push to raise microphone volume
Microphone_Volume_Down	D	Push to lower microphone volume
Microphone_Mute	D	Pulse to toggle microphone mute
Dialer_(0-9)	D	Pulse to send (0-9) to telephone dialer
Dialer_*	D	Pulse to send star to telephone dialer
Dialer_#	D	Pulse to send pound to telephone dialer
Dialer_Pause	D	Pulse to send the pause command to the telephone dialer
Dialer_Redial	D	Pulse to send the redial command to the telephone dialer
Dialer_Flash	D	Pulse to send the flash command to the telephone dialer
Dialer_On/Off_Hook	D	Pulse to toggle the on/off hook state for the telephone dialer
Poll_Device	D	Pulse to poll for device information
From_Device	S	Serial signal to be routed from RS-232 port

 

---

Feedback:

Speaker_Volume_Gauge	A	Analog speaker volume value to be send to the touchpanels gauge
Speaker_Is_Muted	D	High to indicate that the speaker volume is muted
Microphone_Volume_Gauge	A	Analog microphone volume value to be send to the touchpanels gauge
Microphone_Is_Muted	D	High to indicate that the microphone volume is muted
To_Device	S	Serial signal to be routed to RS-232 port