CRESTRON CERTIFIED MODULE
Crestron Details:
This module will control the Speaker & Microphone, Volume & Muting, and Dialing features of the Phoenix Octopus Mixer via RS-232.
This module provides control volume and mute control. The module will poll the device for an update at program start. If needed the Poll_Device command can be triggered to update feedback. This module is System Builder ready.
Crestron Hardware Required: |
C2I-COM6, C2NCOM-2/3, CNX-COM6, CNX-COM2, SY-COM |
Setup of Crestron Hardware: |
RS232 Baud: 9600 Parity: None Data Bits: 8 Stop Bits: 1 |
Cable Diagram: |
CNSP-123
|
Control:
| Speaker_Volume_Up | D | Push to raise speaker volume |
Speaker_Volume_Down |
D | Push to lower speaker volume |
Speaker_Mute |
D | Pulse to toggle speaker mute |
Microphone_Volume_Up |
D | Push to raise microphone volume |
Microphone_Volume_Down |
D | Push to lower microphone volume |
Microphone_Mute |
D | Pulse to toggle microphone mute |
Dialer_(0-9) |
D | Pulse to send (0-9) to telephone dialer |
Dialer_* |
D | Pulse to send star to telephone dialer |
Dialer_# |
D | Pulse to send pound to telephone dialer |
Dialer_Pause |
D | Pulse to send the pause command to the telephone dialer |
Dialer_Redial |
D | Pulse to send the redial command to the telephone dialer |
Dialer_Flash |
D | Pulse to send the flash command to the telephone dialer |
Dialer_On/Off_Hook |
D | Pulse to toggle the on/off hook state for the telephone dialer |
Poll_Device |
D | Pulse to poll for device information |
From_Device |
S | Serial signal to be routed from RS-232 port |
Feedback
| Speaker_Volume_Gauge | A | Analog speaker volume value to be send to the touchpanels gauge |
| Speaker_Is_Muted | D | High to indicate that the speaker volume is muted |
| Microphone_Volume_Gauge | A | Analog microphone volume value to be send to the touchpanels gauge |
| Microphone_Is_Muted | D | High to indicate that the microphone volume is muted |
| To_Device | S | Serial signal to be routed to RS-232 port |